Mobiflight Compatible 4x8bit Output Expander

Click here to purchase the 2x8P wire-to-board connectors separately.

Important: GND and VCC connections are incorrectly labeled on the silkscreen of the board. Please connect the actual ground to where it says VCC on the board and the positive voltage 5V DC to where it says GND on the board. Issue will be fixed with next board revision.

• Common Cathode expander, suitable for LED outputs
• Small board size
• Four serially interfaced shift registers on 1 board
• controlled with clock, data in and latch pins
• cascadable
• easy to use with Mobiflight

The Shift Register Output Expander board is an easy way to increase the number of outputs of a microcontroller, including LED outputs. Current limiting resistor is required. The current per output should not exceed 20mA.

For more information, technical data, setup information and Mobiflight integration guide please refer to the documents in the attachments tab.

Please follow the link below to open the product page for the 2x8P PHD wire-to-board connectors, needed for this board.